Look for the pin hole near end of roller.
Adjusting rv slide out awning.
Make sure it will not fall out.
Thanks for submitting your question on our ask an rv question page.
Roller should now be free of mounting hardware.
Roll up topper on roller.
Step 5 push the foam pieces up and under the bottom lip of the awning to provide further support and tension to the fabric if needed.
You can leave the support arms hanging freely but it might help to simply slide the stops back into the leg channel.
Usually takes 2 people.
Here is brad taylor showing how to adjust an awning fabric.
Adjusting slide topper awnings is fairly simple.
The roller has a spring in it.
Position so the pole pushes the awning out adding tension to the fabric.
Depending on the make and model there is a different method to adjust the tension.
The integrated wind deflector prevents billowing and provides fabric protection for when you travel.
Run slide in about 12.
Special aluminum poles often accompany the rv awning for this use.
Many if not most slide toppers have only one spring which is probably the side that is tight.
Is there a way to adjust the tension on the end of the awning.
How do you tighten up slideout awnings that are sagging.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
Push the aluminum pole in its extended length up to the rv wall and down to the lip of the awning under the awning itself.
Put a cotter pin in the hole.
Rv awning slide out covers install to your camper s slide to keep mildew and rain off from the slide out s roof.
Dear jim well it depends on the size and make of your slide topper.
Roll the awning back up to observe how tight it is.
You do not need to put the screws back in.
Reattach the rear awning leg and lower both leg sections completely.
If your rv slide out awning is equipped with an air bladder use the internal air pump and flip the switch to on to inflate and add tension to the fabric.
The awning over my slideout is sagging on one end but the other end is tight as both ends should be.
Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.
